Robot Swimming Pool Cleaner Intelligent Robotic Vacuum Cleaner 15m or 30m Floating Cable Smart Clean Wall Floor Stair Tiles PVC

2.Unscrew the socket safety cap and insert the floating cable plug into the socket of the Control Box.
Attach the control box to the caddy with the 2 screws.

3. Connect the Control Box to an outside AC power of 110v/240v 50/60Hz.
Notice: Do not allow the Control Box to come in contact with water.
Please ensure the Control Box is placed in a dry, shaded area.

4. Please press the reset button on the Residual Current Device(RCD) where fitted, and ensure the red
stand by light comes on. Then press the red power button on the Control Box or on the Remote Control.

NOTE: if the Control Box does not have an RCD, please press the red power button directly on the Control Box
or the Remote Control.
5.When the cleaning cycle is completed, Unplug the 200V/110v socket.
Pull the robot out of the pool by the handle on the Pool Cleaner.
NOTE: Do not lift the Pool Cleaner out of the water by using the floating cable.

6.Remove the Base Plate and clean the Filter Bag:
Unlock the Latches on the Base Plate and remove the Filter Bag from Base Plate, clean the Filter Bag. Once clean
put the Filter Bag onto its frame, put it back into the Pool Cleaner after the Filter Bag
is dry.
(Note: when re-fitting the Filter Bag to the Base Plate,
please ensure the short side “TAG” is at one of the short ends of the base plate. )

7.At the end of the cleaning cycle, wind the floating cable in a circle by hand and place it on the Pool Cleaner,
and then store the Pool Cleaner in a dry, well-ventilated area. If you have a caddy, please put the Pool Cleaner
floating cable on the caddy.

Packing:

Safety Warnings

Please read this manual carefully before using the Pool Cleaner.

1.Before performing maintenance or service on the Pool Cleaner please ensure the power is

disconnected to avoid personal injury or property loss.

2.The Pool Cleaner is designed for use in swimming pools only. Any other use is prohibited and no

warranty will be provided.

3.Do not swim in the pool whilst the Pool Cleaner is in use in order to avoid personal injury.

4.Do not allow the Control Box to come in contact with water and it is recommended to be placed in

a dry and shaded area.

5.Do not cover the Control Box whilst Pool Cleaner is in use, to avoid overheating.

6.When in use, the Control Box and Caddy Cart must remain 3 meters away from the edge of the pool.

7.Do not use the Pool Cleaner if there is a chance of thunder storm to avoid personal injury.

8.Ensure the Pool Cleaner is fully submerged before turning the Control Box on.

9.After use, make sure the Control Box is disconnected from the pool cleaner and store everythingin a safe, dry and well-ventilated area.

10.If the Pool Cleaner stops working, please refer to “Troubleshooting”.

If you cannot find the root cause, please contact your local distributor.

11.The optimum working temperature for the Pool Cleaner is between 10℃  and 35℃ avoid direct sunlight when not in use.

12.The Pool Cleaner is suitable for the swimming pools no deeper than 3 meters.

13.Lift the Pool Cleaner out of the water by using the Pool Cleaner handles.

Do not lift the Pool Cleaner using the floating cable, as no warranty will be provided for cable misuse.

14.Do not use the Pool Cleaner more than 4hrs at a time(limit of 8Hrs applies forcommercial pool cleaners.).

15.Ensure the electrical outlet is protected by a ground fault interrupter(GFI) or anearth leakage interrupter(ELI).

16.If the supply cord is damaged, order a replacement cable from the local distributor.

17.Children should be supervised to ensure that they do not play with the appliance.This appliance can be used by children aged from 8 years and above and persons withreduced physical, sensory or mental capabilities or lack of experience and knowledgeif they have been given supervision or instruction concerning use of the appliance in a

safe way and understand the hazards involved. Children shall not play with the appliance.

Cleaning and user maintenance shall not be made by children without supervision.

18.The Pool Cleaner must not be used when people are in the water.

19.The pump must supplied through a residual current device(RCD) with a ratedresidual operating current≤30mA